|Оптом:||до 370 000 € штука|
New press KAHL for wood pellets production
Designed for the grinding of dry wood raw materials with humidity10-12% with following moistening, granulation and cooling of end product.
Line is 100% ready for integration into a complete production cycle of wood pellets (required only a section of the grinding and drying)
CAPEX savings for the construction of a pellet plant - The system cost is significantly lower than the new factory KAHL equipment
Delivery basis: EXW Kauno, Lithuania
Brief specifications and purpose of the equipment :
•Hammer mill 660/1000 – is designed for grinding of dry raw materials to the fraction less 4 mm, catching of metal completed by double screw feeder, mill power is 6 tones per hour. Installed capacity of driving gear is 160 kW. The number of hammers is 240 pieces. The number of sieves is 2 pieces.
•Automatic water metering system WD-GLI 15 – is designed for automatic metering installed amount of water by DCS operator (Digital Control System) into mixing screw before ripening hopper. The power is 25-315 liters per hour under pressure that makes up 3-10 bars.
•Mixing screw М 500 – is designed for prior moistening of the grinded dry raw materials before ripening hopper. The screw power is 6 tones per hours. Installed capacity of driving gear is 11 kW.
•Ripening hopper RWB 2205-1 – is designed for even mixing of moistened raw materials and giving them homogeneity by humidity. The volume of ripening hopper is 5, 5 m3. Installed capacity of driving gear is 9, 2 kW.
•Auxiliary water metering system (as required) is designed for moistening of the dry raw materials before loading into pelleting press in case of disrepair of basic moistening system..
•Dosing and mixing screw DM 400 – is designed for final moistening and feeding of grinded dry raw materials to pelleting press. The screw power is 6 tones per hour. Installed capacity of driving gear is 5, 5 kW.
•Pelleting press with flat die 60-1250 – is designed for forced compaction of grinded dry raw materials in canals of the die and forming of fuel granules according to the established quality. The power of pelleting press is 5 tones per hour. Installed capacity of driving gear is 400 kW.
•The number of chaser mills is 5 pieces. The oiling of pelleting press is carried out automatically.
•Electric hoist is designed for acceleration of dismantlement, adjusting and tuning operations of the die and chaser mills of pelleting press.
•Counterflow granule cooler GK19x19 – is designed for cooling, giving strength to granules, dust removal, further metered flow of granules to the vibrosieve.
•Vibrosieve for granules sifting – is designed for separation of fine particles and dust from fuel granules with further feeding of granules on transfer mechanisms.